Land Rover Defender: Chassis
- Suspension
- Wheels and Tires
- Tire Pressure Monitoring System - Description and Operation
- Tire Pressure Monitoring System Locsync
- Tire Pressure Monitoring System - Diagnosis and Testing
- Wheels and Tires - Diagnosis and Testing
- Tire Pressure Sensor
- Wheel and Tire - Removal and Installation
- Tire Pressure Monitoring System Control Module
- Vehicle Dynamic Suspension
- Vehicle Dynamic Suspension - Description and Operation
- Vehicle Dynamic Suspension - Diagnosis and Testing
- Air Line Connector
- Air Suspension Manual Tight Tolerance Setting Mode
- Ride Height Adjustments
- Air Suspension Compressor
- Air Suspension Control Module
- Front Air Reservoir Valve Block
- Air Suspension Reservoir
- Front Suspension Height Sensor
- Rear Air Spring
- Rear Suspension Height Sensor
- Rear Air Reservoir Valve Block
- Ride and Handling Optimization
- Driveline
- Driveline System - General Information
- Driveshaft
- Rear Drive Axle/Differential
- Front Drive Axle/Differential
- Front Drive Halfshafts
- Rear Drive Halfshafts
- Brake System
- Brake System - General Information
- Front Disc Brake
- Rear Disc Brake
- Parking Brake and Actuation
- Brake Controls and Actuation
- Steering System
READ NEXT:
Suspension System - General Information
SPECIFICATIONS
* Measurement taken with vehicle at unladen weight
Wheel Alignment Specification - Front - Air Spring Suspension - Non
Plug-in Hybrid Electric Vehicle (PHEV)
NOTE:
All figures are wit
Wheel Alignment
GENERAL PROCEDURES
GENERAL EQUIPMENT
PART(S)
ACTIVATION
CAUTIONS:
Adjustments must completed on both sides of the vehicle.
Adjustments must be even on both sides of the vehicle.
NOTES:
Only us
SEE MORE:
Diagnostics - Vehicles With: 8HP76 8-Speed Automatic Transmission, AWD
DIAGNOSIS AND TESTING
PRINCIPLES OF OPERATION
For a detailed description of the Automatic Transmission, refer to the
relevant Description and Operation section in the
workshop manual.
INSPECTION, VERIFICATION AND ADDITIONAL WARNINGS FOR ELECTRIC VEHICLES
WARNINGS:
A risk assessment must be perfor
Main Wiring Harness - 90 - Installation
INSTALLATION
The following step(s) applies to:
All vehicles
1. Install the main wiring harness.
2.
Install the wiring harness grommet.
Install the 4 wiring harness clips.
Connect the 2 SOTA antenna link harness electrical connectors.
3.
Connect the 6 roof pod electrical connectors.
Install
© 2010-2026 Copyright www.lrdefender.org
