Land Rover Defender: Suspension
Land Rover Defender 2020-2026 Service Manual / Chassis / Suspension
READ NEXT:
Suspension System - General Information
SPECIFICATIONS
* Measurement taken with vehicle at unladen weight
Wheel Alignment Specification - Front - Air Spring Suspension - Non
Plug-in Hybrid Electric Vehicle (PHEV)
NOTE:
All figures are wit
Wheel Alignment
GENERAL PROCEDURES
GENERAL EQUIPMENT
PART(S)
ACTIVATION
CAUTIONS:
Adjustments must completed on both sides of the vehicle.
Adjustments must be even on both sides of the vehicle.
NOTES:
Only us
Front Wheel Bearing and Wheel Hub Runout Check
GENERAL PROCEDURE
ACTIVATION
NOTE:
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Raise and support the vehicle on a suitable 2 post lift.
2. Remov
SEE MORE:
Headlamp Switch
REMOVAL AND INSTALLATION
REMOVAL
NOTE:
The headlamp switch is an integral component of the Steering Wheel
Module (SWM) and cannot be
serviced separately.
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is alwa
Crankshaft Pulley - Ingenium I4 2.0l Petrol
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
JLR-303-1628
Remover/Installer, Front Crankshaft Seal
JLR-303-1630
Locking Tool, Crankshaft Pulley
PART(S)
REMOVAL
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information
© 2010-2026 Copyright www.lrdefender.org
