Land Rover Defender: Driveline System - General Information
Land Rover Defender 2020-2026 Service Manual / Chassis / Driveline / Driveline System - General Information
READ NEXT:
Driveline System
DIAGNOSIS AND TESTING
PRINCIPLE OF OPERATION
For a detailed description of the driveline system and operation, refer to
the relevant description and operation section
in the workshop manual.
INSPECT
Driveshaft To Rear Differential Disconnection
GENERAL PROCEDURES
SPECIAL TOOL(S)
205-932
Remover, Driveshaft
303-1142
Viscous Coupling Wrench
JLR-205-1032
Remover/Installer, Rear Driveshaft Nut
JLR-205-1033A
Remover/Installer, Rear Driveshaft
Driveshaft
SPECIFICATIONS
NOTE:
Numbers with a green background are a single use component.
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
DESCRIPTION AND OPERATION
COMPONENT LOCATION
Front different
SEE MORE:
Main Wiring Harness - 110 - Installation
INSTALLATION
The following step(s) applies to:
All vehicles
1. Install the main wiring harness.
2.
Install the wiring harness grommet.
Install the 4 wiring harness clips.
Connect the 2 SOTA antenna link harness electrical connectors.
3.
Connect the 6 roof pod electrical connectors.
Instal
Lumbar Assembly
REMOVAL AND INSTALLATION
REMOVAL
WARNINGS:
To avoid accidental deployment and possible personal injury, the
backup power supply must be depleted
before repairing or replacing any airbag Supplementary Restraint System
(SRS) components. To deplete
the backup power supply energy, disconnect the
© 2010-2026 Copyright www.lrdefender.org
