Land Rover Defender manuals

Land Rover Defender: Front Drive Halfshafts

Land Rover Defender 2020-2026 Service Manual / Chassis / Driveline / Front Drive Halfshafts

SPECIFICATIONS

Lubricant

Front Drive Halfshafts

General Specification

Front Drive Halfshafts

NOTE: Numbers with green background are a single use components.

COMPONENT TORQUE LOCATION

Front Drive Halfshafts

Front Drive Halfshafts

READ NEXT:

 Front Left Halfshaft

REMOVAL AND INSTALLATION SPECIAL TOOL(S) 204-506/1 Remover/Installer, Halfshaft 204-506/2 Remover/Installer, Halfshaft Spacer 204-506/3 Remover/Installer, Halfshaft Screw Thread 204-506/5 Retainer

 Front Right Halfshaft

REMOVAL AND INSTALLATION SPECIAL TOOL(S) 204-506/1 Remover/Installer, Halfshaft 204-506/2 Remover/Installer, Halfshaft Spacer 204-506/3 Remover/Installer, Halfshaft Screw Thread 204-506/5 Retainer

 Halfshaft Support Bracket

REMOVAL AND INSTALLATION REMOVAL 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the front right halfshaft. 3. 4. INSTALLATION 1. Torque: 50N

SEE MORE:

 Fuel Tank - Ingenium I4 2.0l Petrol, 90

REMOVAL AND INSTALLATION REMOVAL WARNING: Make sure the fuel tank is suitably supported at all times. Be prepared to collect escaping fuel. CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed. NO

 Air bag locations

Make sure to read and fully understand the relevant warnings before using any of the features in this section. National Highway Traffic Safety Administration (NHTSA) recommends a minimum distance of 10in (25cm) between an occupant's chest and the driver's air bag module. Air bag locations: Front

© 2010-2026 Copyright www.lrdefender.org