Land Rover Defender: Parking Brake and Actuation
SPECIFICATIONS
General Specification
.png)
COMPONENT TORQUE LOCATION
.png)
.png)
COMPONENT TORQUE LOCATION
.png)
.png)
- Electric Park Brake
- Parking Brake
- Electric Park Brake Release When The Vehicle Has No Electrical Power
- Electric Park Brake Service Mode Activation and Deactivation
- Parking Brake Release Actuator
READ NEXT:
Electric Park Brake
DESCRIPTION AND OPERATION
COMPONENT LOCATION
Rear wheel speed sensor (quantity 2)
Instrument Panel Cluster (IPC)
Front wheel speed sensor (quantity 2)
Integrated Power Brake
Electric Park Brake
Parking Brake
DIAGNOSIS AND TESTING
PRINCIPLES OF OPERATION
For a detailed description of the electric park brake, refer to the relevant
Description and Operation section in the
workshop manual.
INSPECTION AND VER
Electric Park Brake Release When The Vehicle Has No Electrical Power
GENERAL PROCEDURES
GENERAL EQUIPMENT
PART(S)
CHECK
NOTES:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is al
SEE MORE:
Rear Door Trim Panel
REMOVAL AND INSTALLATION
REMOVAL
CAUTIONS:
Use a suitable trim tool.
Make sure to protect the paintwork.
NOTES:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always correct.
This procedure contains illus
Electric Park Brake Service Mode Activation and Deactivation
GENERAL PROCEDURES
ACTIVATION
CAUTION:
This procedure requires the vehicle in the Park or Neutral position, with the
ignition turned ON (the engine
must be OFF) and the parking brake system released.
NOTE:
This procedure allows the parking brake to be released when removing and
installing new rea
© 2010-2025 Copyright www.lrdefender.org
