Land Rover Defender: Module Communications Network
Land Rover Defender 2020-2025 Service Manual / Electrical / Electrical Distribution / Module Communications Network
SPECIFICATIONS
Torque Specifications
COMPONENT TORQUE LOCATION
.png)
.png)
Torque Specifications
COMPONENT TORQUE LOCATION
.png)
.png)
- Communications Network - 90
- Communications Network - 110
- Communications Network
- Battery Junction Box
- Body Control Module/Gateway Module Assembly
- Rear Junction Box
- Passenger Junction Box
- Engine Junction Box A
- Engine Junction Box B
READ NEXT:
Communications Network - 90
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 4
NOTE:
Right Hand Drive (RHD) vehicle is shown, Left Hand Drive (LHD) vehicle is
similar.
Cruise Control Module (CCM)
Headl
Communications Network - 110
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 3
NOTE:
Right Hand Drive (RHD) vehicle is shown, Left Hand Drive (LHD) vehicle is
similar.
Headlamp Control Module B (HCMB)
Communications Network
DIAGNOSIS AND TESTING
PRINCIPLES OF OPERATION
For a detailed description of the Communications Network, refer to the
relevant Description and Operation section in
the workshop manual. REFER to: Commu
SEE MORE:
Main Wiring Harness - 110 - Installation
INSTALLATION
The following step(s) applies to:
All vehicles
1. Install the main wiring harness.
2.
Install the wiring harness grommet.
Install the 4 wiring harness clips.
Connect the 2 SOTA antenna link harness electrical connectors.
3.
Connect the 6 roof pod electrical connectors.
Instal
Navigation safety
Make sure the following warnings have
been read and fully understood before
using the navigation system.
Failure to use the navigation system safely
could result in an accident, leading to
serious injury or death.
The navigation system is not a substitute
for driving safely with due care and
atten
© 2010-2025 Copyright www.lrdefender.org
