Land Rover Defender: Electrical Distribution
Land Rover Defender 2020-2026 Service Manual / Electrical / Electrical Distribution
READ NEXT:
Module Communications Network
SPECIFICATIONS
Torque Specifications
COMPONENT TORQUE LOCATION
Torque Specifications
COMPONENT TORQUE LOCATION
Communications Network - 90
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 4
NOTE:
Right Hand Drive (RHD) vehicle is shown, Left Hand Drive (LHD) vehicle is
similar.
Cruise Control Module (CCM)
Headl
Communications Network - 110
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 3
NOTE:
Right Hand Drive (RHD) vehicle is shown, Left Hand Drive (LHD) vehicle is
similar.
Headlamp Control Module B (HCMB)
SEE MORE:
Brake Caliper 2 Piston Floating Caliper
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
REMOVAL
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign material. When
disconnected all openings must be sealed.
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle
Crankshaft Rear Seal - Ingenium I4 2.0l Petrol
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
100-012
Slide Hammer
JLR-303-1674
Installer - Rear Crankshaft Oil Seal
JLR-303-1674A
Installer - Rear Crankshaft Oil Seal
JLR-303-1712
Remover, Rear Crankshaft Seal
GENERAL EQUIPMENT
PART(S)
REMOVAL
NOTE:
This procedure contains some variation in the
© 2010-2026 Copyright www.lrdefender.org
