Land Rover Defender: Instrument Panel and Console
Land Rover Defender 2020-2026 Service Manual / Body and Paint / Instrument Panel and Console
SPECIFICATIONS
Torque specification
COMPONENT TORQUE LOCATION
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
- Interior Trim Inspection
- Floor Console - Vehicles Without: Stowage Compartment
- Floor Console
- Floor Console Cup Holder
- Floor Console Stowage Compartment
- Floor Console Stowage Compartment Lid
- Floor Console Upper Section
- Glovebox
- Instrument Panel Lower Trim
- Instrument Panel Upper Trim
- Overhead Console
- Instrument Panel Cross-Car Beam
READ NEXT:
Interior Trim Inspection
DIAGNOSIS AND TESTING
WARRANTY COMPLIANCE AND PROCEDURES IN RELATION TO HIGH GLOSS VENEERS
NOTE:
Particular care should be taken to prevent damage from rings, studs, zips and
buckles
Verify the cus
Floor Console - Vehicles Without: Stowage Compartment
REMOVAL AND INSTALLATION
REMOVAL
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always correct.
This p
Floor Console
REMOVAL AND INSTALLATION
REMOVAL
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always correct.
This p
SEE MORE:
Air bag locations
Make sure to read and fully understand
the relevant warnings before using any
of the features in this section.
National Highway Traffic Safety
Administration (NHTSA) recommends a
minimum distance of 10in (25cm) between
an occupant's chest and the driver's air
bag module.
Air bag locations:
Front
Battery, Mounting and Cables - Vehicles With: Non-Electric Vehicles
SPECIFICATIONS
Startup battery
Torque Specifications
COMPONENT TORQUE LOCATION
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 1
NOTE:
Vehicle with 5 doors is shown, vehicle with 3 doors is similar.
Startup battery
Battery Monitoring System (BMS) control module
Rear Ju
© 2010-2026 Copyright www.lrdefender.org
