Land Rover Defender: First Aid Kit
FIRST AID KIT - PART NUMBER: VPLCS0319
REMOVAL AND INSTALLATION
WARNING: Accessories which are not properly installed can be dangerous. Read the instructions carefully prior to fitting.
When fitting, comply with instructions at all times. If in doubt, contact your nearest approved retailer.
NOTES:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations for left hand drive vehicles, right hand drive vehicles are similar.
INSTALLATION
1. Open the front passenger door.
2.
Open the lower glove compartment.
3.
Place the first aid kit in the lower glove compartment.
4.
Close the lower glove compartment.
5. Close the front passenger door.
READ NEXT:
Jump Lead
JUMP LEAD - PART NUMBER: VPLVV0090
REMOVAL AND INSTALLATION
WARNINGS:
Accessories which are not properly fitted can be dangerous. Read the
instructions carefully prior to fitting.
Comply with ins
Snow Chains
SNOW CHAINS - PART NUMBER: VPLEW0140
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the
instructions carefully prior to
installation. Comply wi
SEE MORE:
Wheel Bearing and Wheel Hub
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-811
Support, Hub
JLR-204-812
Installer, Hub Bearing
GENERAL EQUIPMENT
REMOVAL
NOTE
Folding fabric roof reset
Make sure that the conditions listed below
are met before carrying out the folding
fabric sunroof reset procedure:
The ambient air temperature is
between 41ºF to 149ºF (5ºC to 65ºC).
The vehicle is at a standstill.
The vehicle's battery is sufficiently
charged and the electrical connection
© 2010-2026 Copyright www.lrdefender.org
