Land Rover Defender: Electric Park Brake Service Mode Activation and Deactivation
GENERAL PROCEDURES
ACTIVATION
CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system released.
NOTE: This procedure allows the parking brake to be released when removing and installing new rear brake pads or brake discs.
1. Press and hold the parking brake switch in the release position.
2. Wait 2 seconds.
3. Press and hold the accelerator pedal in the wide open throttle position.
4. Wait 2 seconds.
5. Turn the ignition Off and back On immediately.
NOTE: An audible noise will be heard to confirm that the parking brake has been released in Service Mode.
6. Release the accelerator pedal and release the parking brake switch to the neutral position.
DEACTIVATION
CAUTIONS:
- This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system in Service Mode.
- Once the rear brake pads or brake discs have been installed, the Service Mode must be cancelled.
1. Press and hold the parking brake switch in the apply position.
2. Wait 2 seconds.
3. Press and hold the accelerator pedal in the wide open throttle position.
4. Wait 2 seconds.
5. Turn the ignition Off and back On immediately.
NOTE: An audible noise will be heard to confirm that the parking brake has been released from the Service Mode.
6. Release the accelerator pedal and release the parking brake switch to the neutral position.
READ NEXT:
Parking Brake Release Actuator
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
PART(S)
REMOVAL
1.
Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and
set the Integrated Power
Brake to the assembly mode.
Genera
Integrated Power Brake System
DESCRIPTION AND OPERATION
COMPONENT LOCATION
Cruise Control Module (CCM)
Integrated Power Brake
Brake pedal
Accelerator Pedal Position (APP)
Steering Angle Sensor Control Module (SASM)
Restrai
SEE MORE:
Loadspace Rubber Mat
LOADSPACE RUBBER MAT - PART NUMBER: 90:
VPLES0566, 110: VPLES0565
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the
instructions carefully prior to
installation. Comply with instructions at all times. If in doubt, contact your
nearest approv
Blind spot assist
Make sure the relevant safety warnings
have been read and understood before
driving the vehicle.
Note: Make sure the Blind Spot Assist
(BSA) system is disabled when connecting
a trailer.
The Blind Spot Assist (BSA) system applies
corrective steering inputs if:
A vehicle is detected in the blind s
