Land Rover Defender: Standard Workshop Practices
Land Rover Defender 2020-2026 Service Manual / General Information / Information Manual / Standard Workshop Practices
- Vehicle In Workshop
- General Installation Instructions
- Screw Threads
- Bolt and Nut Identification
- Ball and Roller Bearings
- Pipes and Hoses
- Electrical Precautions
- Supplemental Restraint System (SRS) Precautions
- Air Bag and Pre-Tensioner Deployment
- Front Air Bag Deployment - Driver and Passenger
- Air Conditioning (A/C) System Precautions
READ NEXT:
Vehicle In Workshop
When working on a vehicle in the workshop always make sure that:
Where practicable, the parking brake is applied and the wheels are
securely chocked to prevent the vehicle
moving forwards or back
General Installation Instructions
COMPONENT REMOVAL
Whenever possible, clean components and the surrounding area before removal.
Blank off openings exposed by component removal.
Following disconnection, seal fuel, oil or hydraulic
Screw Threads
Damaged nuts, bolts and screws must always be discarded. Attempting to
recut or repair damaged threads with a
tap or die impairs the strength and fit of the threads and is not
recommended.
Unl
SEE MORE:
Oil Filter Element
REMOVAL AND INSTALLATION
PART(S)
REMOVAL
WARNINGS:
The spilling of hot oil is unavoidable during this procedure, care
must be taken to prevent scalding.
Be prepared to collect escaping oil.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign materi
Front Fender Trim Panel
REMOVAL AND INSTALLATION
REMOVAL
CAUTION:
Make sure to protect the paintwork.
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always correct.
This procedure contains illustrations showing certain compone
© 2010-2026 Copyright www.lrdefender.org
