Land Rover Defender: Solvents, Sealants and Adhesives
DESCRIPTION AND OPERATION
SOLVENTS
WARNING: Always handle all solvents, sealers and adhesives with extreme care. Some contain chemicals or give off fumes which can be dangerous to health. Always follow the manufacturers instructions. If in doubt about any substance, particularly a solvent, DO NOT use it.
CAUTION: If in doubt about the suitability of any proprietary solvent or sealer for a particular application, contact the manufacturer of the product for information.
The Health and Safety Precautions subsection refers to some commonly used chemicals and materials, hazards associated with their use, and safety measures to be taken. Some of these chemicals may be included as an ingredient in a sealer or adhesive.
SEALERS
Certain procedures in this manual involve the use of sealants during installation of components. Where a sealant is required, the application, together with the Land Rover part number is given in the General Specification at the start of each section and an instruction that a sealant must be used appears in the relevant repair procedure.
It is essential that the sealant(s) specified for a particular procedure are used, DO NOT use any other sealant.
Always remove traces of old sealant using a plastic scraper or suitable solvent, never use emery cloth or metal scrapers.
ADHESIVES
Whenever a procedure involves the use of an adhesive, the adhesive specified must be used and the manufacturer's instructions regarding application together with any health and safety precautions must be followed.
Special Tool Glossary
DESCRIPTION AND OPERATION
SERVICE TOOLS
Special service tools have been developed to facilitate removal, dismantling and assembly of mechanical components in a cost effective and time efficient manner. The use of such special tools also helps prevent the potential for damage to components.
Some operations described in this manual cannot be carried out properly without the aid of the relevant service tools.
All orders and enquiries should be sent direct to: https://jlrequipment.service-solutions.com.
READ NEXT:
Supplementary Restraint System Health and Safety Precautions
DESCRIPTION AND OPERATION
WARNINGS:
Only qualified technicians are allowed to work on pyrotechnic
components.
INHALED: Exposure to pyrotechnic residue may cause low blood
pressure, severe heada
Vehicle Inspection
DESCRIPTION AND OPERATION
NOTE:
For additional information on systems/components that must be checked, refer to
the relevant section in the
Workshop Manual.
Vehicle inspections may be carried out for
SEE MORE:
Wade sensing safety
Make sure the following warnings have
been read and fully understood before
wading. Failure to follow the guidance
could result in vehicle damage, serious
injury, or death.
Avoid driving in floodwater or any
flowing water.
Do not assume that using the wade
sensing feature makes wading any less
dan
Variable Camshaft Timing Actuator
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
JLR-303-1630
Locking Tool, Crankshaft Pulley
JLR-303-1635
Camshaft Setting Tool
JLR-303-1636
Locking Tool, Variable Camshaft Timing Actuator /
Unit
JLR-303-1656
Crank Rotation Tool
PART(S)
REMOVAL
CAUTION:
Before disconnecting any components, make sure t
