Land Rover Defender: Child Seat - Infant Carrier (0kg-13kg)
Land Rover Defender 2020-2026 Service Manual / General Information / Safety / Child Seat / Child Seat - Infant Carrier (0kg-13kg)
CHILD SEAT - INFANT CARRIER (0KG-13KG) - PART NUMBER: VPLRS0397
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
NOTES:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- The Child Seat - Infant Carrier (0kg-13kg) can be installed to a vehicle using the ISOFIX Base (VPLRS0396) or using the vehicle seatbelt. This instruction only shows how the Child Seat - Infant Carrier (0kg-13kg) is installed using the vehicle seatbelt.
- If the ISOFIX Base (VPLRS0396) will be used then refer to the ISOFIX Base instructions for correct installation of the Child Seat - Infant Carrier (0kg-13kg) to the ISOFIX Base.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
REMOVAL
1.
2.
3.
READ NEXT:
Child Seat - (15kg-36kg)
CHILD SEAT - (15KG-36KG) - PART NUMBER:
VPLRS0399
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the
instructions carefully prior to
installati
Child Seat - Group 1 I-size
CHILD SEAT - GROUP 1 I-SIZE - PART NUMBER:
VPLRS0578
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the
instructions carefully prior to
install
Isofix Base
ISOFIX BASE - PART NUMBER: VPLRS0396
REMOVAL AND INSTALLATION
WARNING:
Accessories which are not correctly installed can be dangerous. Read the
instructions carefully prior to
installation. Comply wi
SEE MORE:
Ball and Roller Bearings
When removing and installing bearings, make sure that the following practices
are observed to make sure component
serviceability:
CAUTION:
Service tools have been developed for removing the majority of bearings; these
must always be used where
specified.
Remove all traces from bearing under insp
Message Center
SPECIFICATIONS
Torque Specifications
COMPONENT TORQUE LOCATION
DESCRIPTION AND OPERATION
COMPONENT LOCATION
COMPONENT LOCATION - 1 OF 1
NOTE:
Right Hand Drive (RHD) vehicle is shown, Left Hand Drive (LHD) vehicle is
similar.
Instrument Panel Cluster (IPC) - Virtual display
IPC - Conventional
© 2010-2026 Copyright www.lrdefender.org
