Land Rover Defender manuals

Land Rover Defender: Ski Bag

SKI BAG - 110, PART NUMBER: VPLGS0166

REMOVAL AND INSTALLATION

WARNING: Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

NOTE: It is the responsibility of the vehicle owner to make sure that the ski bag is properly restrained within the vehicle before driving.

Ski Bag - 110

INSTALLATION

NOTE: The ski bag will carry up to 2 pairs of skis and poles with a maximum length of 180 cm.

1.

Ski Bag - 110

Open the tailgate.

2.

Ski Bag - 110

Fold down the center part of the second row seats as illustrated.

3.

Ski Bag - 110

Install the ski bag into the loadspace and over the folded center second row seat as illustrated. The end of the ski bag may need to be located between the front row seats in order to accommodate the ski bag in the vehicle.

4.

Ski Bag - 110

The ski bag can be secured to the vehicle using the shoulder strap as illustrated.

5.

Ski Bag - 110

Close the tailgate.

READ NEXT:

 Front Treadplates

FRONT TREADPLATES - PART NUMBER: 90: VPLES0575PVJ, VPLES0595LAA, LR131474, LR131466, LR131475, LR131467 110: VPLES0576PVJ, VPLES0596LAA, LR131470, LR141462, LR131471, LR131463 REMOVAL AND INSTALLATION

 Loadspace Treadplate

LOADSPACE TREADPLATE - PART NUMBER: VPLES0572 REMOVAL AND INSTALLATION WARNING: Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation.

 Large Pet Access Ramp

LARGE PET ACCESS RAMP - 110, PART NUMBER: VPLRS0517 REMOVAL AND INSTALLATION WARNINGS: Accessories which are not properly installed can be dangerous. Read the instructions carefully prior to inst

SEE MORE:

 Real time traffic information

Make sure the relevant safety warnings have been read and understood before operating the navigation system. Uses live traffic data feeds, allowing for better traffic information, planning, and rerouting, for the user to complete the journey more efficiently. Note: Historical and internet traffic i

 Rear Door Module

REMOVAL AND INSTALLATION GENERAL EQUIPMENT REMOVAL WARNING: To avoid accidental deployment, the Restraints Control Module (RCM) backup power supply must be depleted. Wait at least 1 minute after disconnecting the startup battery ground cable(s) before doing any repair or adjustment to the Supplem

© 2010-2026 Copyright www.lrdefender.org