Land Rover Defender: Parking features
READ NEXT:
Make sure the following warnings and
cautions have been read and fully
understood before driving the vehicle.
Failure to use the parking system safely
could result in damage to the vehicle, or
an acc
Make sure the relevant safety warnings
and cautions have been read and
understood before operating the
parking features.
At vehicle start-up, the parking sensors
may not detect low or high objects,
Make sure the relevant safety warnings
and cautions have been read and
understood before operating the
parking features.
Note: During any park assist maneuver,
the parking aid system remains active a
SEE MORE:
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
JLR-308-844
Remover/Installer, Transmission Control Module
Electrical Connector
GENERAL EQUIPMENT
REMOVAL
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always
INSTALLATION
The following step(s) applies to:
All vehicles
1. Install the main wiring harness.
2.
Install the wiring harness grommet.
Install the 4 wiring harness clips.
Connect the 2 SOTA antenna link harness electrical connectors.
3.
Connect the 6 roof pod electrical connectors.
Instal
© 2010-2026 Copyright www.lrdefender.org
