Land Rover Defender: Integrated Power Brake Assembly Mode
Land Rover Defender 2020-2026 Service Manual / Chassis / Brake System / Brake System - General Information / Integrated Power Brake Assembly Mode
GENERAL PROCEDURES
GENERAL EQUIPMENT
.png)
ACTIVATION
1. Connect the Jaguar Land Rover (JLR) diagnostic equipment and start a new session.
General Equipment: Jaguar Land Rover approved diagnostic equipment
2.
- Navigate to control computer (ECU) diagnostics
- Select " Anti-Lock Brake System Control Module (ABS)" from the list
- Select "Set Assembly Mode"
- Select "Enable" from within the application.
3.
- Save the session and disconnect the JLR diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Set the ignition to the OFF position.
DEACTIVATION
1. Connect the JLR diagnostic equipment and enter the saved session.
General Equipment: Jaguar Land Rover approved diagnostic equipment
2.
- Navigate to ECU diagnostics
- Select " ABS" from the list
- Select "Set Assembly Mode"
- Select "Disable" from within the application.
3.
- Exit the session and disconnect the JLR diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Assess the brake pedal both statically and dynamically.
READ NEXT:
Front Disc Brake
SPECIFICATIONS
General Specification
Torque Specification Vehicle with 2 piston floating caliper
COMPONENT TORQUE LOCATION
NOTE:
Numbers with green background are a single use component.
Torque Sp
Brake Caliper 2 Piston Floating Caliper
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
REMOVAL
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign material. When
disconnected all openings must be se
Brake Caliper 4 Piston Fixed Caliper
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
PART(S)
REMOVAL
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign material. When
disconnected all openings m
SEE MORE:
General Installation Instructions
COMPONENT REMOVAL
Whenever possible, clean components and the surrounding area before removal.
Blank off openings exposed by component removal.
Following disconnection, seal fuel, oil or hydraulic lines immediately
using suitable blanking plugs or caps.
Seal open ends of exposed oil ways using
Fitting latch child restraints
Make sure to read and fully understand
the relevant warnings before using any
of the features in this section.
Do not attempt to fit a LATCH child
restraint to the center rear seating
position. The anchor bars are not
designed to hold a LATCH child restraint
in this position. Install only using se
© 2010-2026 Copyright www.lrdefender.org
