Land Rover Defender: After using the tire repair system
When driving the vehicle, if vibrations, abnormal steering, or noises are experienced, reduce speed immediately.
Drive with extreme caution, at reduced speed, to the first safe place to stop the vehicle. Visually examine the tire and check its pressure. If there are any signs of damage or deformity to the tire, or the tire pressure is below 19 psi (1.3 bar, 130 kPa), do not continue driving.
Doing so could lead to serious injury or death.
Consult a tire repair center as soon as possible, for advice concerning the replacement of a tire after using the tire repair system. Alternatively, consult a retailer/authorized repairer. Failure to do so could lead to serious injury or death.
Only
sealant bottles which are
completely empty should be
disposed of with normal
household waste. Sealant
bottles and the tire inflation
hose, which contain some
sealant, should be disposed of
by a tire specialist or a retailer/
authorized repairer. In addition,
they should be disposed of in
compliance with local waste
disposal regulations.
READ NEXT:
Wheel changing safety
Make sure to read and fully understand
the following warnings. Failure to comply
with the safety instructions could result in
an accident, leading to serious injury or
death.
Note: If in any doubt reg
Tool kit
Make sure the relevant safety warnings
have been read and understood before
using the tool kit.
The tool kit is located beneath the
loadspace floor panel.
The tool kit consists of the following:
SEE MORE:
Brake Caliper 2 Piston Floating Caliper
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
REMOVAL
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign material. When
disconnected all openings must be sealed.
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle
C-Pillar Side Impact Sensor
REMOVAL AND INSTALLATION
REMOVAL
WARNINGS:
To prevent accidental deployment, you must power down the Restraints
Control Module (RCM). Wait at
least 1 minute after you disconnect the startup battery ground cable before
you do any work on the
Supplementary Restraint System (SRS). If you do not
