Land Rover Defender manuals

Land Rover Defender: Vehicle cleaning

READ NEXT:

 The exterior

Following cleaning of the vehicle's exterior particularly with a pressure washer, it is recommended that the vehicle is taken for a short drive to dry out the brakes. Wet brakes may impair the vehicl

 Sensors and cameras

When washing the vehicle, do not aim high pressure water jets directly at any of the sensors and cameras. Do not use abrasive materials or hard/sharp objects, to clean the sensors and cameras. Only u

 After off-road driving

Make sure the areas around air intakes and the front grille are clean and clear of debris. Pay particular attention to the lower grille and radiator. Failure to do so may cause the engine to overheat

SEE MORE:

 Warning Devices - Diagnosis and Testing

DIAGNOSIS AND TESTING PRINCIPLES OF OPERATION For a detailed description of the side obstacle detection system, refer to the relevant Description and Operation section in the workshop manual. INSPECTION AND VERIFICATION CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Subs

 Glass, Frames and Mechanisms - Component Location

COMPONENT LOCATION COMPONENT LOCATION - 1 OF 6 - WINDSHIELD NOTES: Vehicle with 5 doors is shown, vehicle with 3 doors is similar. The windshield is serviceable as whole assembly only. Bracket - Image Processing Module (IPMA) Locator pin (quantity 2) Windshield heater element connector (if

© 2010-2026 Copyright www.lrdefender.org