Land Rover Defender: Storage compartments
STORAGE COMPARTMENTS


Make sure any items stored in the
vehicle are secure and cannot move. If
the vehicle is involved in an accident, or
is subject to sudden braking or a change
of direction, loose items can cause
serious injury.

Do not drink while driving. Driver
distraction can lead to accidents,
potentially causing serious injury or
death.

Do not remove items from, or place
items in, the cup holders while driving.
Driver distraction can lead to accidents,
potentially causing serious injury or
death.
Front storage locations:
- Front cup holders.
- Deep storage area.
- Glovebox: Pull the catch to release the
glovebox. Pull rearward to open.
- Center console storage and fridge: Pull
the catch to release the armrest, then
pull upwards.
- Center console storage and fridge:
Press the button at the rear of the box
to operate the fridge.
- Door bins.
The fridge button on the inside rear lip
operates two cooling modes:
Note: If fast cooling mode is selected, the
refrigerator automatically switches to
normal mode when the operating
temperature is reached. The refrigerator
takes approximately 30 minutes to reach
the operating temperature of
approximately 40ºF (5ºC).
Note: The fridge only operates with the
ignition switched on.
Note: Repeated or prolonged opening of
the fridge reduces its ability to maintain
temperature.
Wireless charging and trinket tray:

Metallic objects may become hot if they
are placed between the mobile device
and the charging mat, which may result
in serious injuries.

- Wireless charging area.
- Sliding tray.
Roof-mounted glasses storage:

Push the glasses compartment (1) as
illustrated to open. Push again to close.

Rear storage locations (all vehicles):
- Map pockets.
- Rear seat cup holders: Fold the center
armrest down.
- Rear door storage.
- Storage hooks: Fold down to use.
- Third row cup holders (110 wheelbase
only).
- Taildoor storage.

Rear storage locations (90 wheelbase)
- Door pockets.
- Rear seat cup holders: Vehicle side
trims.
Note: Contains fluorinated greenhouse
gases in a hermetically sealed equipment
(EN) R134a: [mass in kg] GWP: 1.430.
READ NEXT:
Only use approved accessories. Using any
other equipment may damage the
vehicle's electrical system. If in any doubt,
contact a retailer/authorized repairer.
The engine should be running when using
Metallic objects may become hot if they
are placed between the mobile device
and the charging mat, which may result
in serious injuries.
Note: Do not place anything other than
a Qi-compatible mobile
LOAD CARRYING
Never allow passengers to travel in the
loadspace under any circumstances. All
vehicle occupants should be seated
correctly and should wear a seat belt at
all times when the vehicle is
SEE MORE:
Make sure the relevant safety warnings
have been read and understood before
using the tool kit.
The tool kit is located beneath the
loadspace floor panel.
The tool kit consists of the following:
Jack assembly.
Locking lug nut adapter.
Spare wheel alignment tool.
The jack assembly consists o
Front Wheel Bearing - Vehicles With: 380mm Brake Disc
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bea
© 2010-2026 Copyright www.lrdefender.org
