Land Rover Defender manuals

Land Rover Defender: Fuel filler

Make sure the relevant safety warnings have been read and understood before refueling the vehicle.

Check the fuel pump information carefully, to make sure that the correct fuel is used to refuel the vehicle. Inadequate fuel can reduce engine performance and may cause permanent damage to engine components.

If the vehicle is filled with the incorrect fuel, it is essential to seek qualified assistance before starting the engine.

Inadequate fuel can reduce engine performance and may cause permanent damage to engine components.

Filling station pumps are equipped with automatic cut-off sensing to avoid fuel spillage. Fill the tank until the filler nozzle automatically cuts off the supply. Do not attempt to fill the tank beyond this point.

FUEL TANK CAPACITY

Avoid the risk of running out of fuel. Never intentionally drive the vehicle when the fuel gauge indicates that the tank is empty. When refueling the vehicle after the indicated range reads zero, it may not be possible to add the maximum fuel quantity. The fuel tank retains a small reserve of fuel.

READ NEXT:

 Maintenance

 Breaking-in

The vehicle is built using high-precision manufacturing methods, but the moving parts of the engine must still settle in relative to each other. The breaking-in process occurs mainly in the first 2 00

 Owner maintenance

Any significant or sudden drop in fluid levels, or uneven tire wear, should be reported to a qualified technician without delay. Ignoring low fluid levels or uneven tire wear may cause damage to the

SEE MORE:

 Main Wiring Harness - 90 - Removal

REMOVAL The following step(s) applies to: All vehicles NOTES: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct. This procedure contains illustrations for left hand drive vehicles, right hand dr

 Drive Pinion Seal

REMOVAL AND INSTALLATION SPECIAL TOOL(S) 100-012 Slide Hammer 205-067 Preload Gauge 303-1300 Remover, Crankshaft Seal 307-520 Installer, Output Shaft Seal 308-246 Installer, Front Seal JLR-205-1010 Remover, Bearing JLR-205-1013 Installer, Bearing JLR-205-890 Support, Differential JLR-205-89

© 2010-2026 Copyright www.lrdefender.org