Land Rover Defender manuals

Land Rover Defender: Extended mode

Make sure the relevant warnings and cautions have been read and fully understood before adjusting the electronic air suspension.

Extended mode is an automatic suspension height setting that raises the vehicle to assist maneuvering in the event that the vehicle is:

The instrument panel displays a message and the off-road indicator lamp on the front control panel flashes to confirm the vehicle is in extended mode.

Note: Extended mode cannot be selected manually.

The vehicle can be raised higher when in extended mode, if required. To further raise the vehicle:

1. Press and hold the brake pedal.

2. Press and hold the up button (3) on the front control panel for longer than 3 seconds.

ACCESS HEIGHT

Make sure the relevant warnings and cautions have been read and fully understood before adjusting the electronic air suspension.

The vehicle can be lowered to allow easier access. To lower the vehicle to access height:

1. Make sure the vehicle is in the normal height setting.

2. Press the down button (2) on the front control panel.

The instrument panel displays a message to confirm the vehicle is moving to access height.

Access height can be requested while the vehicle is moving. The suspension does not lower until the vehicle's speed is reduced sufficiently. If the vehicle's speed isn't reduced sufficiently within 1 minute, the request is canceled.

Access height can also be selected:

The vehicle can be configured to enter access height automatically.

The normal height setting is automatically resumed once the vehicle is driven. To manually select the normal height setting, press the up button (3) on the front control panel.

READ NEXT:

 Auto access height

Make sure the relevant warnings and cautions have been read and fully understood before adjusting the electronic air suspension. The vehicle can be configured to enter access height automatically via

 Rear height adjust

Make sure the relevant warnings and cautions have been read and fully understood before adjusting the electronic air suspension. The height of the rear suspension can be adjusted manually via the but

 Brakes

SEE MORE:

 Air Suspension Compressor

REMOVAL AND INSTALLATION GENERAL EQUIPMENT EQUIPMENT NAME 2 mm punch PART(S) REMOVAL CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed. NOTE: This procedure contains some variation in the ill

 Catalytic Converter - Ingenium I4 2.0l Petrol

REMOVAL AND INSTALLATION SPECIAL TOOL(S) JLR-303-1666 Remover/Installer, NOx/Oxygen Sensor PART(S) REMOVAL WARNING: Observe due care when working near a hot exhaust system. NOTE: This procedure contains some variation in the illustration depending on the vehicle specification, but essential i

© 2010-2026 Copyright www.lrdefender.org