Land Rover Defender manuals

Land Rover Defender: Autonomous emergency braking (AEB) safety

Land Rover Defender 2020-2024 Owner's Manual / Collision avoidance / Autonomous emergency braking (AEB) safety

Make sure the following warnings and notes have been read and fully understood before driving the vehicle.

Failure to understand the Autonomous Emergency Braking (AEB) system could result in an accident, leading to serious injury or death.

The AEB system is a driving aid only.

The driver is responsible for driving with due care and attention, and in a safe manner for the vehicle, the occupants, and other road users. The driver should observe all road signs, road markings and any potential emergency braking situations, and act appropriately.

The AEB system uses forward-facing cameras and forward-facing radars to detect real vehicles and pedestrians, plus other certified target objects. AEB is not designed to detect any other objects, including non-industry approved targets.

In order for AEB to operate, it must be able to detect a clear image of the object and be able to determine its movement. If neither of these occur, the AEB system may not operate.

Safety belts should be worn by all vehicle occupants, for every trip, no matter how short. Failure to do so greatly increases the risk of death or serious injury in the event of an accident.

Make sure that the windshield is kept clean and that the camera's line of sight is not obstructed by label or stickers.

Failure to do so can cause incorrect AEB operation.

Note: AEB efficiency is dependent on the condition of the current driving surface and the vehicle's speed, tires, and braking system.

Note: When a vehicle is parked outside, in full sunlight and in high ambient temperatures, the forward-facing camera may reach an internal temperature of 210ºF (99ºC). In this state, the instrument panel displays a warning message. When the forward-facing camera cools to less than 190ºF (88ºC), normal operation is resumed, and the warning message extinguishes.

Note: When the vehicle's electrical system is first switched on, AEB may require an initialization period before it is fully functional. AEB efficiency is limited during this period.

READ NEXT:

 Autonomous emergency braking (AEB)

Make sure the relevant safety warnings and notes have been read and understood before driving the vehicle. Note: Not all vehicles are fitted with Autonomous Emergency Braking (AEB). Consult a retail

 Autonomous emergency braking (AEB) limitations

Vehicle detection Autonomous Emergency Braking (AEB) does not operate if: The vehicle is negotiating a tight corner. The forward-facing cameras are dirty or obscured. The forward-facing radars a

 Blind spot monitor

Make sure the relevant safety warnings have been read and understood before driving the vehicle. The blind spot monitor system monitors an area adjacent to, and approximately 28 ft (8.5 m) behind, t

SEE MORE:

 Halfshaft Support Bracket

REMOVAL AND INSTALLATION REMOVAL 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the front right halfshaft. 3. 4. INSTALLATION 1. Torque: 50Nm 2. Torque: 63Nm 3. Install the front right halfshaft.

 Second Row Seat Armrest

REMOVAL AND INSTALLATION REMOVAL NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct. This procedure contains illustrations showing certain components removed to provide extra clarity. 1.

© 2010-2024 Copyright www.lrdefender.org