Land Rover Defender manuals

Land Rover Defender: Fluid filler locations

Land Rover Defender 2020-2026 Owner's Manual / Fluid level checks / Fluid filler locations

Do not start the engine, or drive the vehicle, if leaked fluid could possibly make contact with a hot surface. Any leaked fluid coming into contact with a hot surface, such as the exhaust, could result in combustion. Seek qualified assistance immediately.

Always observe and follow the safety precautions when working in the engine compartment. Failure to do so may result in serious injury or death.

Note: Further information on safety precautions can be found in the relevant section of the Owner's Handbook.

A number of simple checks and routine maintenance must be carried out at regular intervals.

2.0L gasoline engine

Land Rover Defender. Fluid level checks

  1. Brake fluid reservoir cap.
  2. Engine oil filler cap.
  3. Engine oil level dipstick.
  4. Engine coolant reservoir filler cap.
  5. Washer fluid reservoir filler cap.

3.0L in-line 6 cylinder gasoline engine

Land Rover Defender. Fluid level checks

  1. Brake fluid reservoir cap.
  2. Engine oil filler cap.
  3. Engine oil level dipstick.
  4. Engine coolant reservoir filler cap.
  5. Washer fluid reservoir filler cap.

READ NEXT:

 Checking the engine oil level

Check the engine oil frequently. If any significant or sudden drop in the oil level is noted, seek qualified assistance. Never allow the engine oil level to fall below the lower mark on the dipstick

 Topping up the oil

The vehicle's warranty may be invalidated if damage is caused by using oil that does not meet the required specification. Before driving off-road, top up the engine oil level to the maximum mark on t

 Topping up the coolant

Never remove the coolant reservoir filler cap when the engine is hot. Escaping steam or scalding water could cause serious personal injury. Unscrew the filler cap slowly, allowing the pressure to es

SEE MORE:

 Operation

POWER FLOWS Operation of the transmission is controlled by the TCM, which electrically activates various solenoids to control the transmission gear selection. The sequence of solenoid activation is based on programed information in the TCM memory and physical transmission operating conditions such

 Handles, Locks, Latches and Entry Systems - Description

CENTRAL DOOR LOCKING SYSTEM CONTROLS The CDL system provides the user with control over the locking and unlocking of the vehicle entry points. The user can operate the CDL system inside or outside the vehicle. Manual operation of the CDL system is achieved using the following: The smart key and t

© 2010-2026 Copyright www.lrdefender.org